Menü
Sprache
Start-up of Flexlock Visible
Flexlock is supplied unprogrammed as standard but can be ordered with the desired pre-programmed function.
Pre-programmed lock according to specification
The Flexlock locks can be ordered with the desired pre-programmed function. To activate the lock, you pull out the plastic flap that acts as a battery isolator strip. On activation, the locks must be kept at a distance from each other and also away from metal objects. The lock is now ready to be installed. A pre-programmed lock already has its service card and programming card added to it.
Unprogrammed lock
To activate the lock you will need an activation pin, a programming card and a suitable lithium battery of the type recommended by Swedstyle AB (a version of CR123A, 3V, min. 1400 mAh).
1. Insert the battery – take care to ensure correct polarity. Fit the battery cover.
2. Press the activation pin into the hole on the rear. Keep it pressed in for 3 seconds. The lock will now emit a succession of beeps for 7 seconds. Within the 7 seconds during which the lock beeps, place the programming card over the lock. You will hear a beep as confirmation signal and the programming card has now been added.
3. Also add the service card, which acts as a master key. To add a service card to the lock, you need the programming card and the service card.
4. Place the programming card over the lock. You will hear a succession of uniform beeps for 7 seconds. Within 7 seconds, place the service card over the lock until you hear a beep as confirmation signal. The service card has now been added.
5. The lock is now ready to be installed and used in the mode that you have programmed. Read more about installation here.
Svenska
English (UK/International)
Deutsch
